Gateway 960 Manual do Utilizador descarregar pdf (Página 39)

Chapter 4: Installing Components

www.gateway.com

■ If cable-select is available (drive assignments will be marked on the

cable), the IDE cable assigns the master/slave positions to the drives

it connects. You can override these assignments using the jumpers on

the drives.

■ If cable-select is not available and only one drive is attached to an IDE

controller cable, configure the drive as master if it is a CD or DVD

drive. If two drives of any type are attached to the cable, configure

one as master and one as slave.

■ If you are connecting two IDE drives to the cable, connect the middle

cable connector to the slave drive and connect the end cable

connector to the master (boot) drive.

■ You may need to configure the drives you install using the BIOS Setup

utility. Press F2 at startup to open the BIOS Setup utility.

Installing an IDE drive

Use these instructions to install or replace a diskette, CD or DVD, tape, or IDE

hard drive.

To install an IDE drive:

1 Follow the instructions in “Preventing static electricity discharge” on

page 27.

2 Follow the instructions in “Opening the server case” on page 28.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 129 130

Sem comentários

Gateway 960 Manual do Utilizador Página 39